Construction Site Elevator SC200 FIC-07 Rack and Pinion Hoist Fully
Intelligent Control construction lift
Equipped with Fully Intelligent System, with functions including
floor selection, floor calling and automatic cage landing/stop,
automatic open/close cage doors and floor doors, fault detect,
display and alarm, personnel biologic recognition and permissions,
etc.
* Apply high efficiency and long work life gear reducers.
* Racks set in the middle of mast section to reduce Partial load
torque of cages and make the machine run more stably
and smoothly.
*Apply non-eccentric rollers. No need to adjust rollers after
installation. That means faster installation and
less error caused by installation.
*Integrated cage roof. Cage roof is made by a full plate of tread
plate welded one time to complete, with high
strength and no water leakage in rainy days.
* Flap door for loading/unloading ramp
* Additional 'C' door at cage side for convenient
loading/unloading.
* Interior Car Lighting
* Base-Level Alarm
* Interlocked roof hatch
* Drop test facility with remote pendant
* Be equipped with a frequency control unit (FC), with closed-loop,
which gives very smooth starting and stopping with
low starting current and less wear and tear.
* Composite Power & Control Cable, or Sliding contact line
(Integrated Conductive Rail or Busbar).
* Easy access to electrical panels for maintenance
* Certified safety brake system
Technical Data
Item & Article No. | SC200, FIC-07 |
Number of Cages | Single Cage |
Payload Capacity | 2,000 KG |
Lifting Speed | 0–46 meter/minute, full loaded |
Max. Lifting Height | 250 m / 450 m * |
Cage Size (internal) | 3.2(Length)*1.5(Width)*2.35(Height) Meter |
Cage Doors | Modularized Entrance Door and Discharge Door, and Third Door at the
long side of cage |
Engine Power | 2*15 KW |
Motor Control | Frequency Control (FC) |
Invertor Power (KW) | 1*37 KW |
Gearbox | Helical Gearbox |
Safety Device Type | Centrifugal Brake |
Power Supply Range | 380–500 V, 50 or 60 Hz, 3 Phase |
Type of Mast | Square Column 650*650 mm with Bolted Rack |
Length Mast Section | 1.508 m |
Rack Module | 8 |
* Increased lifting height on request. 250 m with step-up
transformer only. 400 m with step-up/step-down transformer. |